Airaid 200-512-1 User Manual Page 1

Browse online or download User Manual for Accessories for air Airaid 200-512-1. Airaid 200-512-1 User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Parts List
#1 Poweraid Spacer x1
#2 6mmx45mm Bolts x3
#3 6mm Flat Washers x3
#4 Fiber Gasket x1
#5 1/2” Extension Plate x3
#6 6mm Flat Head Screw x3
Tools Required For Installation
5/16”,4mm, & 10mm Sockets
5/32” Allen Wrench
Ratchet and Extension
Installation Instructions
Part Number 200-512-1
99-06 GM Trucks and SUVs
2007 GM “Classic” Trucks
4.8L, 5.3L, 6.0L, & 8.1L
04 Pontiac GTO 5.7L
1. Disconnect the negative battery cable!
Loosen one bolt and remove the beauty cover. Pry
the tube from the clamp on the radiator hose.
Loosen the hose clamps on each end of the intake
tube and remove the tube.
2. Using a 10mm socket, remove the three nuts that
hold the throttle body to the intake manifold.
Thank you for purchasing the Poweraid Throttle Body Spacer. Please read the in-
struction manual carefully before proceeding with the installation. Contact AIRAID @ (800)
498-6951 8:00 AM - 5:00 PM MST Weekdays for questions regarding fit or instructions that
are not clear to you. Your Poweraid Throttle Body Spacer was carefully inspected and
packaged. Check that no parts are missing, or were damaged during shipping. If any
parts are missing, please contact AIRAID.
3. Using a 4mm socket, remove the three studs that
hold the throttle body to the intake manifold. No
need to remove the throttle body, leave it hang
where it is.
4. If you have an electronic throttlebody, (no
cables) skip to step #6. Using a 5/16” socket, re-
move and save 3 bolts that hold the throttle cable
bracket to the intake manifold. (Disregard steps
#4, #5, and #8, if you are working on a 8.1L).
Page view 0
1 2

Summary of Contents

Page 1 - Ratchet and Extension

Parts List #1 Poweraid Spacer x1 #2 6mmx45mm Bolts x3 #3 6mm Flat Washers x3 #4 Fiber Gasket x1 #5 1/2” Extension Pla

Page 2 - 01/14/09

10. Re-install the intake tube and tighten the hose clamps. Re-install the plastic holder from step #1. Re-install the beauty cover and bolt. Re-conn

Comments to this Manuals

No comments