Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 [email protected] www.airaid.
com
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
REV.12.2.13
FILTER IDENTIFICATION
850-233 Airaid Oiled Media 851-233 Airaid SynthaMax Dry Media - Red
852-233 Airaid SynthaMax Dry Media - Black 853-233 Airaid SynthaMax Dry Media - Blue
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
For your Oiled media filter
we suggest using the
AIRAID Filter Tune-Up Kit!
10. Install the coupler and two #60 hose
clamps on the throttle body as shown. Do
not tighten hose clamps. Fasten the facto-
ry breather hose to air conditioning line
using the supplied zip tie.
11. Install the supplied grommet into Airaid
MIT as shown.
12. Carefully install the temperature sensor into
the Airaid MIT as shown. Make sure it’s
pushed all the way in and the plug is connected
to the wire harness.
13. Install the MIT into the hump hose first,
and then into the throttle body coupler. Adjust
to fit, and tighten the hose clamps.
14. Re-install the engine cover by firmly push-
ing it back into the grommets.
15. Re-install the oil fill cap.
16. Check for any foreign material in the in-
take path. Re-check your work for tight-
ness. Re-connect the negative battery
cable.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals