Airaid 300-236 User Manual download pdf (Page 3)

Component Identification

1. Airaid Premium Filter 1

2. Cool Air Box 1

3. Filter Adapter 1

4. Weather Strip 33” 1

5. 1/4-20 X 5/8” Hex Bolt 3

6. 1/4” Flat Washer 3

7. 1/2” x 90° Elbow 1

8. 1/4”NPT x1/2” Barbed Fitting 1

9. 1/2” x 3/4” Barbed Connector 1

10. 1/4”NPT Hex Plug 1

11. 3/4” x 2 1/2” Breather Hose 1

12. Adapter Gasket 1

13. 22” Breather hose (NOT USED) 1

14. 1/2”Connector (NOT USED) 1

1. Disconnect the negative battery cable!

Loosen the two hose clamps on the flexible intake

tube, one at the airbox lid and one at the resonator.

Slide the flexible tube off of the lid and the reso-

nator and remove it from the vehicle.

2004-and later Models: Disconnect the cr ank-

case breather hose that attaches to the factory air-

2. Rock the airbox back and forth as you are lifting

it straight up to remove it from the vehicle. It is

only held in by grommets.

3. Remove and save three grommets from the bot-

tom of the factory airbox. They will be reused in

step #4.

4. Install the three grommets removed in step # 3

into the bottom of the Airaid Cool Air Box (CAB)

(#2) at the locations shown here.

5. Using a 13mm socket, remove the two bolts that

hold the airbox mount to the inside right fender.

Save them for reinstallation in step #8.

Gasket

Filter Adapter

6. Install the adapter gasket (#12) and filter adapter

(#3) into the CAB using three 1/4-20 x 5/8” bolts

(#5) and flat washers (#6) as shown. Refer to the

line drawing above for reference.

7. Install the 1/4” NPT x 1/2” barbed fitting (#8)

into the filter adapter as shown.

2003 Models: Install the 1/4”NPT plug (#10) in

place of the barbed fitting.

1/4” Bolts From Step #7

Fitting

8. Install the CAB into the vehicle by aligning the

grommets over the locating pins on the factory air-

box mount. Reinstall the factory bolts thru the CAB

and into the fender that were removed in step #4.

9. Reinstall the factory air intake tube and tighten

the two hose clamps.

Remove the rubber hose from the end of the factory

crankcase breather tube.

Installation Instructions

For Part Numbers:

300-236 720-476 Airaid Oiled Media Filter

301-236 721-476 SynthaMax Dry Media Filter - Red

302-236 722-476 SynthaMax Dry Media Filter - Black

303-236 723-476 SynthaMax Dry Media Filter - Blue

2003-08 Dodge Ram 1500/2500/3500

3.7L, 4.7L, 5.7L

2009-12 Dodge Ram 1500

4.7L

Full color instructions can be viewed on our web site at Airaid.com. Use the Product Search function to find your part number, and click View Details.

1 2 3 4

Comments to this Manuals

No comments

Airaid 300-236 User Manual Page 3

Comments to this Manuals

Related products and manuals for Air equipment Airaid 300-236