Airaid 400-239-1 User Manual download pdf (Page 2)

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected] www.airaid.com

P/N 790-551 Aerosol Spray

P/N 790-550 Squeeze Spray

Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions

regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-

ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter

is reusable and should be cleaned periodically.

12. Install the Weather Strip (#5) to the Panel assembly

as shown, with the contour rolling away from the filter

area.

13. Install the Airaid Premium Filter (#1) on to the Air

Meter Tube and tighten the clamp.

14. Double check your work!

Make sure there is no foreign material in the

intake path. Make sure all clamps, hoses,

bolts, and screws are tight. Double check the

hood clearance!

Reconnect the negative battery cable!

REV.09.29.14

11. Slide the factory intake tube onto the Airaid Tube and

tighten the clamp. Reconnect the Mass Air Flow sensor.

B

10. Install the Airaid intake assembly onto the factory

airbox bottom. Insert the Panel tabs into the slots first,

then lower the tube side down and fasten the three

clips.

Tabs

FILTER IDENTIFICATION

720-478 Airaid Oiled Media 721-478 Airaid SynthaMax Dry Media - Red

722-478 Airaid SynthaMax Dry Media - Black 723-478 Airaid SynthaMax Dry Media - Blue

For your Oiled media filter we

suggest using the AIRAID Filter

Tune-Up Kit!

Synthamax Air Filters do not require oil.

Service air filter as needed by cleaning

with common non-petroleum all-purpose

household cleaner and water. Simple

Green®, Formula 409® or equivalent

works great. Apply cleaner to outside of

air filter and allow to soak. Then flush

filter clean from the inside out with a gar-

den hose and repeat steps if necessary.

Do not apply high pressure water or air

to clean filter. Allow filter to air dry and

reinstall.

Airaid 400-239-1 User Manual Page 2

Comments to this Manuals

Airaid 400-239-1 User Manual Page 2

Comments to this Manuals

Related products and manuals for Air equipment Airaid 400-239-1