13. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses, bolts,
nuts, connectors, and screws are tight.
Reconnect the negative battery cable!
Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 [email protected] www.airaid
.com
REV.10.11.13
P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILTY! The air filter is
reusable and should be cleaned periodically.
9. Reinstall the mounting hardware from step #5 secur-
ing the MAF bracket to the factory mounting bracket.
8. Install the panel assembly into the vehicle aligning the
panel mounting hose over the top of the radiator over-
flow tank. Replace the 6mm bolt that was removed in
step #4 into the inner fender.
7. Assemble the MAF sensor housing, MAF gasket,
MAF bracket and two panels as shown using the four
bolts and nuts from step #5.
10. Reinstall the air intake tube and tighten the two hose
clamps. Reconnect the two rubber hoses to the intake
tube. Reconnect the air intake temperature sensor wiring
harness. Reinstall the engine beauty cover using the
three factory bolts from step #1.
11. If you Do have a hood mat, install the Airaid Premi-
um Filter onto the MAF bracket and tighten the filter.
Next install the weatherstrip (#4) onto the top of the
panel assembly as shown. If your vehicle Does Not have
a hood mat, proceed to step # 12.
12. If your vehicle Does Not have a hood mat, install the
panel extension (#4) as shown using five 6-32 Phillips
head screws (#5), flat washers (#6), and kep nuts (#7).
Next install the weatherstrip (#4) onto the top of the
panel assembly as shown.
For your Oiled media filter we
suggest using the AIRAID Filter
Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals