Airaid 200-268 User Manual download pdf (Page 2)

Airaid Filter Co. 2688 E Rose Garden Ln. Phoenix AZ 85050 (800) 498-6951 [email protected]m www.airaid.com

REV.11.12.13

P/N 790-551 Aerosol Spray

P/N 790-550 Squeeze Spray

10. Transfer the Mass Air Flow sensor from the factory

airbox onto the Filter adapter. Reconnect the MAF.

11. A) Install the 1/4” NPT Bar bed Fitting (#12)into

the Airaid Intake Tube(#2).

B) Install the Hump Hose (#5) , Coupler (#6) and

clamps (#11) onto the Intake Tube as shown. Leave the

clamps loose for now.

12. Install the Airaid Intake Tube assembly onto the

MAF fir st, and then onto the throttlebody. Adjust for

fit, and tighten all hose clamps. Reinstall the hose an-

chor into the Airaid Intake Tube.

13. Install the 3/8” Breather Hose (#7) onto the Barbed

fitting and factory hard line.

14. Install the Airaid Premium Filter (#1) onto the Filter

Adapter, and tighten the hose clamp. Install the weather

strip (#8) onto the Airaid Cold Air Box. (Hint: Start

from one corner and work your way around for ease of

install.)

15..Reinstall the engine cover.

Double check your work!

Make sure there is no foreign material in the

intake path. Make sure all clamps, hoses, bolts,

and screws are tight. Double check the hood

clearance.

Reconnect the negative battery cable!

First

Second

WARNING! If your vehicle has a Vehicle Emission Contr ol Infor mation decal affixed to the factory air box, a

new replacement label must be obtained and installed in a readily visible position in the engine compartment in order to

remain CARB compliant. Failure to do so will prevent the vehicle from passing a smog check. Replacement labels can

be ordered from your local dealership. Regulations state that the VECI label shall not be affixed to any equipment

which is easily detached from the vehicle. Label placement, under the hood on a painted surface is recommended.

Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions

regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are

missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-

ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter

is reusable and should be cleaned periodically.

FILTER IDENTIFICATION

720-472 Airaid Oiled Media 721-472 Airaid SynthaMax Dry Media - Red

722-472 Airaid SynthaMax Dry Media - Black 723-472 Airaid SynthaMax Dry Media - Blue

For your Oiled media filter we

suggest using the AIRAID Filter

Tune-Up Kit!

Synthamax Air Filters do not require oil.

Service air filter as needed by cleaning

with common non-petroleum all-purpose

household cleaner and water. Simple

Green®, Formula 409® or equivalent

works great. Apply cleaner to outside of

air filter and allow to soak. Then flush

filter clean from the inside out with a gar-

den hose and repeat steps if necessary.

Do not apply high pressure water or air

to clean filter. Allow filter to air dry and

reinstall.

1 2

Comments to this Manuals

No comments

Airaid 200-268 User Manual Page 2

Comments to this Manuals

Related products and manuals for Air equipment Airaid 200-268