Airaid Filter Co. 26
88 E Rose Garden Ln. P
hoenix AZ 85050
(800) 498
-6951 A[email protected]m www.airaid.com P/N 790-551 Aerosol Spray
P/N 790-550 Squeeze Spray
Thank you for purchasing the Airaid Intake System. Contact Airaid @ (800) 498-6951 8:00 AM - 5:00 PM MST weekdays for questions
regarding fit or instructions that are not clear to you. Your Airaid Intake System was carefully inspected and packaged. Check that no parts are
missing, or were damaged during shipping. If any parts are missing, contact Airaid. The air filter element is protected from direct exposure to wa-
ter and debris; care should be taken not to drive through deep water. WATER INGESTION IS THE DRIVERS RESPONSIBILITY! The air filter
is reusable and should be cleaned periodically.
14. Remove the factory engine cover mounting bracket
from the intake manifold and install the two 6mm
x30mm Bolts (#10) as shown. They are to be installed
from behind and protrude forward when installed
properly.
10. Install the Airaid Intake Tube into the Hump Hose
first, and then into the Reducing Coupler. Adjust for fit,
and tighten all four Hose Clamps.
11. Install the 5/8” Hose (#16) onto the Barbed fitting in
the Intake Tube. Insert the Barbed “Y” Fitting (#14) into
the 5/8” Hose and secure using the two Speed Clamps
(#17).
12. Reconnect the factory PCV breathers and spring
clamps to the Barbed “Y” Fitting. Reconnect the Mass
Air Flow sensor.
18. Double check your work!
Make sure there is no foreign material in the
intake path. Make sure all clamps, hoses,
bolts, and screws are tight. Double check the
hood clearance!
Reconnect the negative battery cable!
REV.02.13.15
15. Reinstall the bracket onto the intake manifold and
place a Spacer (#13) onto each 6mm bolt.
16. Install the Airaid Premium Filter (#1) onto the Filter
Adapter then install the Weather Strip (#7) onto the top
of the Cold Air Box with the contour rolling away from
the Filter.
17. Reinstall the engine cover in the reverse order in
which it was removed, rear first, front last. Only now it is
to be secured using the two Acorn Nuts (#11) and two
1/4” flat washers.
13. On 4WD models: Secure the differential breather to
the MAF harness with the 8” Zip Tie. Trim off the ex-
cess.
FILTER IDENTIFICATION
720-476 Airaid Oiled Media 721-476 Airaid SynthaMax Dry Media - Red
722-476 Airaid SynthaMax Dry Media - Black 723-476 Airaid SynthaMax Dry Media - Blue
For your Oiled media filter
we suggest using the AIRAID
Filter Tune-Up Kit!
Synthamax Air Filters do not require oil.
Service air filter as needed by cleaning
with common non-petroleum all-purpose
household cleaner and water. Simple
Green®, Formula 409® or equivalent
works great. Apply cleaner to outside of
air filter and allow to soak. Then flush
filter clean from the inside out with a gar-
den hose and repeat steps if necessary.
Do not apply high pressure water or air
to clean filter. Allow filter to air dry and
reinstall.
(7 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals